VLT OPERATING INSTRUCTIONS
TO TURN ON: Install a fresh 9 volt alkaline battery taking note of the proper polarity. Use the end of the supplied magnet and hold it against the ON sticker. It will chirp and cycle through the four modes for as long as you hold it there. One chirp is regular point only, two chirps is dual mode regular, three chirps is grouse point only and four chirps is dual mode grouse. When you hear the desired number of chirps, move the magnet away. TO TURN OFF: Hold the end of the magnet against the OFF sticker for a second until a chirp is heard.
The letters VLT stand for very low tone. This beeper collar operates from 900 hertz to 1400 hertz. We ship them set at maximum volume and at a 1000 hertz frequency setting. If you want or need a different sound remove the battery cover and battery and make adjustments using a small screwdriver. Since the pots are under the battery you should start by making frequency adjustments a little at a time (about an 1\8 of a turn, then re install the battery and go through the modes. You should find the frequency that is right for your ears. For warranty information, please visit our website: www.dogbeepers.com
Mode 1 Regular, Point-Only
Beeps every other second after 8 sec. motionless.
Mode 2 Regular, Point & Run
As above when pointing, double-beep every 8 sec. when running.
Mode 3 Grouse, Point-Only
Beeps every other second after 4 sec. motionless.
Mode 4 Grouse, Point & Run
As above when pointing, double-beep every 4 sec. when running.
VOLUME ADJUSTMENT
BATTERY NEG.
FREQUENCY ADJUSTMENT
SPARE SCREWS
BATTERY POS.
BOTTOM VIEW WITH BATTERY REMOVED